Description of the Software Modules and Parameters
Parameter manual b maXX BM5800
Document No.: 5.16029.03
393
of 814
3
159.12 Axis Index input parameter
Axis index of the master axis.
The input parameter of a double axis can originate from the other axis, as well. Therefore,
both axes motion can be combined.
159.14 Basic value index calculation
At parameter-controlled processing the base value is subtracted from the input parame-
ter.
159.15 Shift factor index calculation
After the base value was subtracted from the input parameter, the resulting value is shift-
ed to the right by the shift factor, if the input parameters are integer data types.
159.16 Output parameter
The cam generator writes on this output parameter. All cyclic writable parameters can be
used as output parameters.
159.17 Target axis
The own axis or all axes can be selected at a double axis as a target axis. The selection
of the other axis only is not possible.
To Next Page
Loading...