BERTHOLD TECHNOLOGIES Uni-Probe LB 490 - Page 352

38477BA2B
3 – 352 25.5.09
4 Calibration Volume 3
 Select YES.
 Confirm the dialog with
OK.
This completes the background measurement.
4.3.2 Empty Calibration
Tip
For more information on the conditions for empty calibration please
refer to Volume 3, section 6.2.
If the following display is not visible, select it from the Start menu
as follows:

ACCESS TO SETUP  FULL ACCESS  CALIBRATION I/O  NO. OF CAL.
POINTS (2)  1-2 POINT CURVE
See also "Setting the Operating Mode for Calibration" on
page 3–349.
 Select
ADJUST LO.CAL. PT.