90 | Chapter 2: Installation
Repacking the Strip Washer
n The instrument’s packaging design is subject to change over time. If the
instructions in this section do not appear to apply to the packaging materials
you are using, please contact BioTek’s Technical Assistance Center for
guidance.
Uninstall the strip washer:
1. Reverse the installation
procedure: (as described on page
35) to detach the strip washer
from the MultiFlo FX.
2. Separate the manifolds from their
tubing and allow all fluid vessels
to completely dry.
3. Pack the washer module and its
accessories in the shipping
container.
4. Repack the cardboard and foam
shipping materials to secure the
items in place.
5. Tape the box closed.
MultiFlo™ FX Multi-Mode Dispenser
To Next Page
Loading...
