62 | Chapter 2: Installation
Install the Syringe Dispenser Component
The Syringe dispenser is an optional component and ships separately. Inspect and
unpack the shipping container. Skip this part of the installation process if it is not
applicable.
l 1 - Syringe Dispenser module (autoclavable)
l 2 - interface cable
l 3 - tubing bracket
l 4 - priming trough inserts
l 5 - dispense manifolds
l 6 - shelf
l 7 - supply bottles and tubing with check valves
l Not shown: thumbscrews (2) and a USB flash drive.
Review the placement options for the Syringe dispenser and follow the applicable
instructions:
Syringe Dispenser Placement Options on the facing page
MultiFlo™ FX Multi-Mode Dispenser
To Next Page
Loading...
