Install the Waste Tubing | 29
Install the Waste Tubing
A length of tubing and a bracket to hold it is provided to drain the priming trough
into a waste container. It's safer to perform this task before removing the shipping
hardware.
Underside of MultiFlo showing priming trough waste tubing
Important note: The waste
tubing must lay flat to
properly drain the priming
trough. The side bracket
provided with the instrument
supports this goal, but it may
not be needed in your lab,
depending on where you
position the dispenser and its
waste receptacle.
You will need:
l Philips head screwdriver (small)
l Waste tubing: 4' provided (PN 7213010)
l Possibly scissors or knife to cut tubing to desired length
l Side bracket provided
l Waste vessel: to capture discarded fluid
To install the tubing:
Install Side Bracket for Waste Tubing
BioTek Instruments, Inc.
To Next Page
Loading...
