60 | Chapter 2: Installation
Peri-pump Reservoir Holder
Peri-pump Reservoir Holder attached to Peri-pump
MultiFlo FX models with a
Peri-pump dispenser
include the convenient Peri-
pump reservoir holder (PN
7210509). The simple bracket
clips onto the front of the
Peri-pump to hold a variety
of vessels.
You can significantly reduce
the dead volume, saving
precious fluid, by cutting
the cassette tubing to make a
shorter fluid path. See
Shorten the Dispense
Cassette Tubing on the
facing page.
The reservoir holder has two components, a bracket and
a strap.
1. Clip the bracket onto the front of the Peri-
pump. When properly installed the bracket
hides the hazard label.
2. Place the supply vessel (reservoir) on the
bracket and wrap the strap around both the
vessel and the bracket: fit the strap's molded
balls into the round slots.
Depending on the size of the vessel, it may be necessary to tuck the ends of the
strap into the bracket, too, to keep the slack out of the way.
n Important: Always remove the tubing from the fluid before releasing the
tension on the cassette or changing cassettes.
MultiFlo™ FX Multi-Mode Dispenser
To Next Page
Loading...
