36 | Chapter 2: Installation
the tubing secure and away from moving parts.
You need a Philips screwdriver.
1. First, remove the screws and
washers that will attach the washer
to the back panel.
2. Align the slots on the side of the
washer module with the two posts
near the base. Simultaneously,
align the screw holes on the top of
washer unit.
3. Use the screws removed in the first
step to attach the module to the
instrument.
4. Connect the serial cable from the
washer module to its port on the
back of the instrument.
back panel
MultiFlo™ FX Multi-Mode Dispenser
To Next Page
Loading...
