BRP Evinrude E-TEC G2 - Page 240

240
Powerhead
Powerhead Removal
Starboard
Remove the following hose clamps and hoses:
1. 51.5 mm clamp – Oil fill hose (upper), remove
the hose from the center (top) frame.
2. 10.5 mm clamp – Oil tank vent hose, remove
the hose from the oil tank.
3. 14.5 mm clamp – Remote oil fill hose, remove
the hose from the oil tank.
Disconnect the electrical connectors from the fol-
lowing:
4. Crankcase oil pump (oil tank).
5. Low oil switch (oil tank).
6. Oil level sender (oil tank).
7. Trim relay, three Amp connectors and two 2
ring terminals (1 ground on the block and 1 on
the starter solenoid).
8. Starter solenoid (small ring terminal).
9. Remove the 6 oil supply hoses from the crank-
case oil pump.
Remove the following:
10.The trim relay from the oil tank.
11.The three nuts and washers retaining the oil
tank. Then remove the oil tank
009174
1
2, 3
8
10
6
4
9
11
11
11
5
7