BRP Evinrude E-TEC G2 - Page 241

241
Powerhead
Powerhead Removal
11
Port
Remove the following hose clamps and hoses:
1. 15.7 mm Tee fitting, hose from tee fitting to
DPS module, remove the hose from the tee fit-
ting.
2. 15.7 mm Hose, DPS module to adapter,
remove the hose from the adapter fitting.
3. 34.6 mm Y-fitting hose to adapter, remove the
hose from the Y-fitting.
4. 21.0 mm Tee fitting/ thermostat hose to
adapter, remove the hose from adapter fitting.
5. Tie strap Exhaust back pressure hose, remove
the hose from adapter fitting.
Disconnect the electrical connectors from the fol-
lowing:
6. Exhaust temperature sensor
7. Shift actuator
8. DPS module
Remove the following:
9. The three nuts and washers retaining the DPS
module. Then remove the DPS module and
cooling hoses as an assembly.
009175
1
2
4
6
5
8
9
7
3