Stern and Swivel
Stern & Swivel Bracket
336
Then remove the thread protector from the fly-
wheel threads.
Install Engine Lifting Fixture, P/N 357667, com-
pletely into the flywheel. If needed, turn the fly-
wheel until the lifting rings of the fixture are
aligned front to back as shown.
IMPORTANT: Carefully thread the lifting fixture
into the threads of the flywheel at least 6 complete
turns. Do NOT cross-thread the threads of the lift-
ing fixture into the threads of the flywheel.
Make sure the off-set lifting eye is aligned to the
REAR of the engine.
Use the off-set lifting eye to support the engine.
Fasten an appropriate chain hook to the off-set lift-
ing eye.
Remove the four lower mount bolts.
Remove the two retaining nuts and washers from
the upper mount studs.
1. 4 inch plug
2. 3.5 inch plug
3. Thread protector
009425
009274
WARNING
To avoid personal injury, make sure the lifting
capacity of the hoist is at least twice the
weight of the outboard.
DO NOT allow the lift hook or chain from the
hoist to come in contact with any part of the
engine during lifting.
1. Centerline lifting eye
2. Off-set lifting eye (to REAR of engine)
009177
1. Lower mount bolts (port side shown)
009275
1. Nuts
009276
To Next Page
Loading...
