BRP Evinrude E-TEC G2 - Page 340

Stern and Swivel
Stern & Swivel Bracket
340
plate and anode. Remove the spray plate and
anode.
Remove the four screws from the stern bracket
plate and remove the plate.
Remove the lower ramp bracket screw and lower
bracket.
Remove the two screws and o-rings from the
stern bracket cover. Remove the cover and large
o-ring.
Use a punch and hammer to bend the locking tab
from the spanner nut slot. Use Spanner Socket,
P/N 359225, to remove the spanner nut. Remove
the locking washer.
1. Bottom screws
2. Upper screws
3. Spray plate
4. Anode
009629
1. Screws
2. Stern bracket plate
009630
1. Screw
2. Bracket
009632
1
1
2
2
3
4
1
1
2
1
1
2
1
1. Screws and o-rings
2. Cover
3. Large o-ring
009631
1. Spanner nut
2. Locking washer
009633
3
2
1
2
1