Canon imageCLASS D530 - Page 152

4
4
4-76
4-76
Disassembly/Assembly > Document Exposure/Feeder System > Removing the Flatbed Motor Unit(MF4870dn/MF4830d) > Procedure
Disassembly/Assembly > Document Exposure/Feeder System > Removing the Flatbed Motor Unit(MF4870dn/MF4830d) > Procedure
1)Move the CIS unit[1].
[1]
2)Move the gear[1], and remove the belt[2] from the gear[3]
Caution.
Grease is applied on the shaft[1] of the contact sensor, so be careful not to let the
belt[2] come in contact with the shaft.
[1]
[2]
F-4-182
[2]
[3]
[1]
3)Remove the guide cover[1]
[1]
4)Free the harness[1] and the grounding wire[2] from the hole[A] of the reader unit and the
harness guide[B]
[1][2]
[A] [B]
F-4-183
F-4-184
F-4-185