Canon imageCLASS D530 - Removing the Engine Controller PCB(Mf4820 D)

4
4
4-181
4-181
Disassembly/Assembly > Controller System > Removing the Engine Controller PCB(MF4820d) > Procedure
Disassembly/Assembly > Controller System > Removing the Engine Controller PCB(MF4820d) > Procedure
7)Remove the main motor[1]
2 screws(with washer)[2]
x2
[2]
[1]
Caution:
When installing the main motor, be sure to install the harness[1] to the upper side of
the motor.
[1]
F-4-457
F-4-456
Removing the Engine Controller PCB(MF4820d)
■
Preparation
1) Remove the left cover
2)Remove the copyboard cover and reader unit.
3)Remove the right cover
4)Remove the front cover unit.
5)Remove the upper cover.
6)Remove the duplex feed unit.
7)Remove the main controller PCB
■
Procedure
1)Remove the main controller mounting plate[1]
• 1 screw(with washer)[2]
• 1 screw(black TP)[3]
x2
[1]
[2][3]
F-4-458