Canon imageCLASS D530 - Removing the Flatbed Motor Unit (L418 S;L410;L190)

4
4
4-130
4-130
Disassembly/Assembly > Document Exposure/Feeder System > Removing the Flatbed Motor Unit (L418S/L410/L190) > Procedure
Disassembly/Assembly > Document Exposure/Feeder System > Removing the Flatbed Motor Unit (L418S/L410/L190) > Procedure
Removing the Flatbed Motor Unit (L418S/L410/L190)
■
Preparation
1) Remove the left cover.
2)Remove the DADF unit and reader unit
3)Remove the DADF unit.
4)Remove the copyboard glass
■
Procedure
Caution.
When assembling/disassembling the copyboard glass, take care not to lose the 2
CIS unit spacers [1].
When assembling/disassembling the copyboard glass, do not touch the copy reading
area [A] of the CIS unit.
[1]
[A]
1)Move the CIS unit[1].
[1]
2)Move the gear[1], and remove the belt[2] from the gear[3]
Caution.
Grease is applied on the shaft[1] of the contact sensor, so be careful not to let the
belt[2] come in contact with the shaft.
[1]
[2]
F-4-305