Canon imageCLASS LBP6780dn - Page 169

3
3
3-47
3-47
Disassembly/Assembly > Controller System > Removing the Main Motor > Procedure
Disassembly/Assembly > Controller System > Removing the Main Motor > Procedure
CAUTION:
• When installing the Gear Cover, be sure to align the shaft with the 5 Shaft Holes [2]
of the Gear Cover [1].
• When installing the Gear Cover, be sure to route the harness [3] of the Multi-purpose
Tray Pickup Solenoid around the guide section of the Gear Cover [1] one and a half
times in a clockwise direction.
[1]
[3]
[2]
F-3-100
2) Remove the Harness Guide Holder [1].
• 1 Harness Guide [2]
• 1 Claw [3]
[1]
[2]
[3]
F-3-101
3) Remove the Main Gear Cover [1].
• 4 Screws [2]
• 1 Edge Saddle [3]
[1]
[2]
[2]
[3]
x4
4) Remove the Main Gear [1].
• 1 Parallel Pin [2]
5) Remove the gear [3].
[1]
[2]
[3]
F-3-102
F-3-103