Cisco ASR 1001 Hardware Installation Guide

Tools and Equipment
The tools and equipment listed below are recommended as the minimum necessary to install the Cisco ASR
1000 Series Router. You may need additional tools and equipment to install associated equipment and cables.
You may also require test equipment to check electronic and optical signal levels, power levels, and
communications links.
•
Phillips hand screwdriver
•
3.5mm flat-blade screwdriver
•
Tape measure (optional)
•
Level (optional)
•
Power drill
•
8-gauge wire
•
Rack-mount brackets
•
Cable-management brackets
Unpacking and Verifying Shipping Contents
When you receive your chassis, perform the following steps and use the shipping contents checklist from the
next section:
SUMMARY STEPS
1.
Inspect the box for any shipping damage. (if there is damage contact your service representative).
2.
Unpack the Cisco ASR 1000 Series Router.
3.
Perform a visual inspection of the chassis.
4.
After you have unpacked the system verify that you have received all of the required components. Using
the packing list as a guide, take the following steps to check the contents of the Cisco ASR 1000 Series
Router shipping container:
5.
Check the contents of the boxes containing accessory items. Verify that you have received all equipment
listed in your order.
6.
Check that all Cisco ASR 1000 Series route processors, Cisco ASR 1000 Series embedded services
processors, Cisco ASR 1000 Series SPA interface processors (SIPs), and power supplies you ordered are
installed in the chassis. Ensure that the configuration matches the packing list.
Cisco ASR 1000 Series Router Hardware Installation Guide
134
Preparing Your Site for Installation
Tools and Equipment

Cisco ASR 1001 Specifications

General

Ethernet LAN	Yes
Cabling technology	10/100/1000Base-T(X)
Networking standards	-
Ethernet LAN data rates	10, 100, 1000 Mbit/s
Ethernet interface type	Gigabit Ethernet
USB ports quantity	1
Ethernet LAN (RJ-45) ports	4
VPN tunnels quantity	8000
Product color	Gray
Rack capacity	1U
AC input voltage	85 - 264 V
Power source type	AC
AC input frequency	50 - 60 Hz
Power consumption (typical)	250 W
Safety	UL60950-1 CSA, C22.2 No. 60950-1-03, EN 60950-1, IEC 60950-1, AS/NZS 60950.1
Certification	FCC 47CFR15 Class A AS/NZS CISPR 22 CISPR 22 Class A EN55022 Class A ICES-003 Class A VCCI Class A CNS-13438 Class A EN61000-3-2 EN61000-3-3
Internal memory	8192 MB
Operating altitude	0 - 3048 m
Storage temperature (T-T)	0 - 50 °C
Operating temperature (T-T)	0 - 40 °C
Storage relative humidity (H-H)	5 - 95 %
Operating relative humidity (H-H)	5 - 90 %

Weight and Dimensions

Depth	461.5 mm
Width	439.42 mm
Height	43.43 mm
Weight	11350 g