Cisco ASR 1001 Hardware Installation Guide

DC power supply On (|)/
Off (O)
6DC power supply LEDs2
DC power supply handle7DB-25 alarm connector*3
——
DC power supply fan4
*For information about
the DB-25 alarm
connector, how it works,
and Cisco ASR 1000
route processor LEDs, see
the xref “How Cisco
ASR1000-RP Alarm
Monitoring Works”
section on page 2-20.
Note: Shielded cables
must be used to connect
to the DB-25 alarm
connector on both the AC
and DC power supplies,
in order to comply with
FCC/EN55022/CISPR22
Class A emissions
requirements.
Removing the DC Power Supply from the Cisco ASR 1004 Router
Before you can remove a DC power supply from the Cisco ASR 1004 Router, you must remove power from
the power supply. Follow these steps to remove power and the DC power supply from the chassis.
SUMMARY STEPS
1.
Make certain that the chassis ground is connected before you begin removing the DC power supply.
2.
Switch the power supply circuit breaker switch to Off (O).
3.
Locate the terminal block on the rear of the chassis on the power supply. The following figure shows the
DC power supply terminal block.
4.
Remove the slotted plastic cover from the terminal block.
5.
Locate the power supply ground stud (see xref fig). Remove the ground (GND) cable from the DC power
supply.
6.
Loosen and remove the Kepnut screw, washer, and ground lug in that order.
7.
Loosen the captive screws on the DC power supply.
8.
Grasping the power supply handles, pull the power supply from the chassis.
9.
Replace the DC power supply within five minutes.
Cisco ASR 1000 Series Router Hardware Installation Guide
560
Removing and Replacing FRUs from the Cisco ASR 1000 Series Routers
Removing and Replacing a DC Power Supply in Cisco ASR 1004 Router

Cisco ASR 1001 Specifications

General

Ethernet LAN	Yes
Cabling technology	10/100/1000Base-T(X)
Networking standards	-
Ethernet LAN data rates	10, 100, 1000 Mbit/s
Ethernet interface type	Gigabit Ethernet
USB ports quantity	1
Ethernet LAN (RJ-45) ports	4
VPN tunnels quantity	8000
Product color	Gray
Rack capacity	1U
AC input voltage	85 - 264 V
Power source type	AC
AC input frequency	50 - 60 Hz
Power consumption (typical)	250 W
Safety	UL60950-1 CSA, C22.2 No. 60950-1-03, EN 60950-1, IEC 60950-1, AS/NZS 60950.1
Certification	FCC 47CFR15 Class A AS/NZS CISPR 22 CISPR 22 Class A EN55022 Class A ICES-003 Class A VCCI Class A CNS-13438 Class A EN61000-3-2 EN61000-3-3
Internal memory	8192 MB
Operating altitude	0 - 3048 m
Storage temperature (T-T)	0 - 50 °C
Operating temperature (T-T)	0 - 40 °C
Storage relative humidity (H-H)	5 - 95 %
Operating relative humidity (H-H)	5 - 90 %

Weight and Dimensions

Depth	461.5 mm
Width	439.42 mm
Height	43.43 mm
Weight	11350 g