Cisco ASR 1001 Hardware Installation Guide

Verifying the Hardware Configuration
To display and verify the hardware features, enter the following commands:
• show version—Displays the system hardware version; the installed software version; the names and
sources of configuration files; the boot images; and the amount of installed DRAM, NVRAM, and flash
memory.
• show diag chassis—Displays the IDPROM information for the assemblies in the chassis.
• show diag slot/subslot—Displays the IDPROM information for the subassemblies in the chassis.
Checking Hardware and Software Compatibility
To check the minimum software requirements of the Cisco IOS software with the hardware installed on your
Cisco ASR 1000 Series Routers, Cisco maintains the Software Advisor tool on Cisco.com. This tool does not
verify whether Cisco ASR 1000 Series SIPs or SPAs within a system are compatible; but the tool provides
the minimum Cisco IOS requirements for individual hardware modules and components.
To access this tool, you must have a Cisco.com login account.Note
To access the Software Advisor, click Login at Cisco.com, type Software Advisor in the search box, and
click Go. Click the link for the Software Advisor Tool.
Choose a product family or enter a specific product number to search for the minimum supported software
needed for your hardware.
Configuring the Cisco ASR 1000 Series Routers at Startup
This section explains how to create a basic running configuration for your Cisco ASR 1000 Series Routers.
You need to acquire the correct network addresses from your system administrator or consult your network
plan to determine correct addresses before you can complete the router configuration.
Note
Before continuing the configuration process, check the current state of the router by entering the show version
command. The show version command displays the release of Cisco IOS software that is available on the
router.
For information on modifying the configuration after you create it, see the Cisco IOS configuration and
command reference guides.
To configure a Cisco ASR 1000 Series Routers from the console, you must connect a terminal or terminal
server to the console port. To configure the Cisco ASR 1000 Series Routers over your management Ethernet,
you must have the router’s IP address available.
Cisco ASR 1000 Series Router Hardware Installation Guide
467
Cisco ASR 1000 Series Routers Power Up and Initial Configuration
Verifying the Hardware Configuration

Cisco ASR 1001 Specifications

General

Ethernet LAN	Yes
Cabling technology	10/100/1000Base-T(X)
Networking standards	-
Ethernet LAN data rates	10, 100, 1000 Mbit/s
Ethernet interface type	Gigabit Ethernet
USB ports quantity	1
Ethernet LAN (RJ-45) ports	4
VPN tunnels quantity	8000
Product color	Gray
Rack capacity	1U
AC input voltage	85 - 264 V
Power source type	AC
AC input frequency	50 - 60 Hz
Power consumption (typical)	250 W
Safety	UL60950-1 CSA, C22.2 No. 60950-1-03, EN 60950-1, IEC 60950-1, AS/NZS 60950.1
Certification	FCC 47CFR15 Class A AS/NZS CISPR 22 CISPR 22 Class A EN55022 Class A ICES-003 Class A VCCI Class A CNS-13438 Class A EN61000-3-2 EN61000-3-3
Internal memory	8192 MB
Operating altitude	0 - 3048 m
Storage temperature (T-T)	0 - 50 °C
Operating temperature (T-T)	0 - 40 °C
Storage relative humidity (H-H)	5 - 95 %
Operating relative humidity (H-H)	5 - 90 %

Weight and Dimensions

Depth	461.5 mm
Width	439.42 mm
Height	43.43 mm
Weight	11350 g