CDM-625A Advanced Satellite Modem MN-CDM625A
Updating Firmware Revision 4
4–12
G. Type "bye" to terminate the FTP session, and then close the Command-line window.
5) Use the modem front panel menus, the CDM-625A HTTP Interface ‘Admin | Firmware |
Packet Processor’ page, or issue the Serial Remote Interface <0/SWR? or <0/FRW? query as
shown previously, to verify that the PC-to-Modem IP Packet Processor firmware FTP file
transfer was successful.
6) Use the modem front panel menus, or the CDM-625A HTTP Interface ‘Admin | Firmware |
Base Modem’ or, as needed, ‘Admin | Firmware | Packet Processor’ page to select the
desired firmware image to boot from:
A. Using the modem front panel menus:
• First, to select the desired Boot Image, make sure that you are operating in LOCAL
mode (CONFIG: Remote
Local).
• Then, go to the SELECT: Utilities Firmware Base-modem Select menu
branch and use the
▲▼ arrow keys to select the Next Reboot Image as 1 or 2.
• Press ENTER when done.
B. Using the CDM-625A HTTP Interface: Typical for either ‘Admin | Firmware’ page, use
the drop-down list to select Image#1 or Image#2. Click [Submit] to save.
To Next Page
Loading...
