Comtech EF Data CDM-625A - Page 355

CDM-625A Advanced Satellite Modem MN-CDM625A
Serial-based Remote Product Management Revision 4
8–41
Parameter
Command
(Instruction
& Qualifier)
Length of
Arguments
Description of Arguments
Response to
Command
Query
(Instruction &
Qualifier)
Response to Query
Radius
Server
Password Type
RAT=
1 byte, 0 or 1
Command or Query.
Sets or returns the RADIUS Server password type in the form x, where
0=PAP
1=CHAP
EXAMPLE: <0/RAT=0
NOTE: Parameter available only through Telnet CLI. Command available at Administrator level only.
RAT=
RAT?
RAT*
RAT#
RAT?
RAT=x
(see Description of
Arguments)
Radius
Server Shared
Secret
RAS=
Up to 64 bytes
Command or Query.
Sets or returns the RADIUS Server shared secret
EXAMPLE: <0/RAS=comtech
NOTE: Parameter available only through Telnet CLI. Command available at Administrator level only.
RAS=
RAS?
RAS*
RAS#
RAS?
RAS=xxx…
(see Description of
Arguments)
Precision Time
Protocol
Transport
Mode
PTU=
1 byte
Command or Query.
Sets or returns PTP Transport Mode in the form x, where:
0=Multicast
1=Unicast
PTU=
PTU?
PTU*
PTU#
PTU?
PTU=x
(see Description of
Arguments)
Precision Time
Protocol
Unicast Master
PTS=
15 bytes
Command or Query.
Sets or returns the PTP Unicast Master IP Address in the form xxx.xxx.xxx.xxx.
PTS=
PTS?
PTS*
PTS#
PTS?
PTS=xxx.xxx.xxx.xxx
(see Description of
Arguments)
Precision Time
Protocol
Unicast Sync
Interval
PTY=
2 bytes
Command or Query.
Sets or returns the PTP Unicast Master IP Address in the form xx, where:
-6= 64 Messages per second
-5= 32 Messages per second
-4=16 Messages per second
-3=8 Messages per second
-2=4 Messages per second
-1=2 Messages per second
+0=1 Message per second
+1=1 Message every 2 seconds (default value)
PTY=
PTY?
PTY*
PTY#
PTY?
PTY=xx
(see Description of
Arguments)
Port
Monitoring
Enable
PME=
1 byte
Command or Query.
Sets or returns port monitoring in the form x, where:
0=Disabled
1=Enabled
NOTE: MAC Learning must be enabled to monitor properly.
EXAMPLE: <0/PME=0
PME=
PME?
PME*
PME#
PME?
PME=x
(see Description of
Arguments)
Port
Monitoring
Source Port
PMS=
1 byte
Command or Query.
Sets or returns the port monitoring source (monitoring) port in the form x, where:
1=Port 1
2=Port 2
3=Port 3
4=Port 4
5=WAN
NOTES:
1) Source port and destination port must be different.
2) WAN (5) monitors Packet Processor traffic if it presents.
EXAMPLE: <0/PMS=1
PMS=
PMS?
PMS*
PMS#
PMS?
PMS=x
(see Description of
Arguments)