A
Connectrix Private Enterprise MIB (ef-6000)
A-31
Using SNMP to Manage the Switch
Generic Traps
The following generic traps can be received from the switch:
◆ coldStart — Reports that the SNMP agent is reinitializing due to
a power-on reset.
◆ warmStart — Reports that the agent is reinitializing due to an
IML or IPL.
◆ authenticationFailure — An indication that the agent has
received an improperly authenticated protocol message. By
default, this trap is disabled but may be enabled using the
Product Manager. (Refer to Agent Configuration on page A-8.)
Enterprise Specific
Trap
The following enterprise-specific traps can be received from the
switch:
◆ ef6000PortScn(1) — Generated whenever an Fc_Port changes its
operational state; for example, on line to off line.
◆ ef6000FruScn(2) — Generated whenever a FRU changes its
operational state.
◆ ef6000PortBindingViolation(3) — Generated whenever the
switch detects that a port binding violation has occurred.
ef6000TTADirection Specifies the throughput direction of the threshold (transmit=1, receive=2,
either=3). This only applies when the alert type is Throughput Thrreshold Alert.
ef6000TTATriggerDuration Specifies the amount of timeduring a threshold alert interval that the trigger
must be exceeded before an alert is generated. This only applies when the alert
type is Throughput Thrreshold Alert.
ef6000CTACounter Specifies statistical counter or counter set to be monitored. This object is not
supported in the current release.
Table A-18 Threshold Alerts Table (continued)
Variable Provides:
To Next Page
Loading...