D
CLI OverviewThe config Branch
D-15
Command Line Interface
The config Branch
The config branch of the CLI command tree contains commands that
set parameter values. These values are not temporary (session)
values, but are retained across power cycles.
The commands in the config branch can by used only by the
Administrator.
config.features.installKey
Syntax installKey “featureKey”
Purpose This command allows the user to install a feature set that is enabled
by the provided feature key.
Description
The switch must be off line to install a feature key. After the key is installed,
you must IPL the switch; the connection to the CLI will be lost at this time
and must be reestablished.
Parameters This command has one parameter:
Command Example
Root> config features installKey AaBb-CCdD-eeFF-gH
featureKey
Specifies the key you have received to enable
optional software feature on a specific product.
A feature key is a string of case-sensitive,
alphanumeric ASCII characters.
The number of characters may vary in the
format; however, the key must be entered
exactly, including the hyphens. An example of a
feature key format is XxXx-XXxX-xxXX-xX.
To Next Page
Loading...
Need help?
General
