EMC Connectrix DS-32M2 - Configuring Switch Identification; Web Server Interface - Configure Switch Identification

C
C-8 Connectrix DS-32M2 User Guide
Configuring the Switch from a Web Server
Configuring Switch Identification
The Configure: Switch page allows you to configure the switch name,
description, location, and contact person. The Name, Location, and
Contact variables configured here correspond to the SNMP variables
sysName, sysLocation, and sysContact. These variables are used by
SNMP management workstations when obtaining data from
managed switches.
Refer to Configuring Switch Identification on page 5-2 for information
on performing this operation through the Connectrix Manager.
To configure switch identification:
1. On the Configure window (Figure C-3 on page C-7), click the
Switch tab. This displays the window in Figure C-4.
Figure C-4 Web Server Interface — Configure Switch Identification