C
Configuring Operating Parameters
C-11
Configuring the Switch from a Web Server
Configuring Operating Parameters
The operation described here allows you to configure Fibre Channel
operating parameters for the switch. Refer to Configuring Operating
Parameters on page 5-6 for descriptions of the parameters and
information on performing this operation through the Connectrix
Manager.
To configure the parameters:
1. Set the switch off line as follows:
a. Click Operations at the left side of the Web Server window.
b. On the Operations window, click the Online State tab. This
displays the current state:
c. Click Set Offline.
This message appears:
Your operations changes have been successfully activated
2. On the Configure:Switch window (Figure C-4 on page C-8), click
Operating Parameters.
This displays the window in Figure C-6 on page C-12.
To Next Page
Loading...
Need help?
General
