D
CLI OverviewThe config Branch
D-19
Command Line Interface
config.port.name
Syntax name portNumber “portName”
Purpose This command sets the name for a port.
Parameters This command has two required parameters:
Command Example
Root> config port name 4 “Sam’s tape drive”
config.port.speed
Syntax speed portNumber portSpeed
Purpose This command sets the speed for a port.
Description A port can be configured to operate at 1 Gb/sec, 2 Gb/sec, or at a
negotiated speed.
The port speed can be set only to 1 Gb/sec, if the switch speed is
1 Gb/sec. An attempt to set the port speed to 2 Gb/sec or to negotiate
in a switch with a 1 Gb/sec switch speed results in an error message.
If the port speed is set to negotiate, the port and the device to which it
is attached negotiate the data speed setting to either 1 Gb/sec or
2Gb/sec.
Port speed changes temporarily disrupt port data transfers.
Parameters This command has two required parameters.
portNumber
Specifies the port number. Valid values for the
DS-32M2 are 0 through 31.
portName
Specifies the name for the port. The port name
must not exceed 24 characters in length.
portNumber Specifies the port number. Valid values for the
DS-32M2 are 0 through 31.
portSpeed Specifies the speed of the port. Valid values are
1g, 2g, and negotiate.
To Next Page
Loading...
Need help?
General
