5
Configuring Ports
5-11
Configuring the Switch
Configuring Ports
Use the procedures in this section to configure identification and
operating parameters for ports on the switch. Port configuration data
is stored in NV-RAM on the switch.
Follow these steps to configure ports:
1. Click Configure on the Product Manager menu bar and select
Ports on the drop-down menu.
This displays the Configure Ports dialog box (Figure 5-6).
Figure 5-6 Configure Ports Dialog Box
2. Configure the port parameters, referring to Port Parameters on
page 5-12.
3. Click Activate to activate changes and close the dialog box.
If the format for a WWN or nickname in the Bound WWN
column is invalid, an error message appears.
If the Port Binding column is checked for a port and the WWN or
nickname in the Port Binding column does not match the device
actually connected to the port, a warning (Figure 5-7) appears,
listing all ports that have a mismatch.
To Next Page
Loading...