5
5-40
Connectrix DS-32M2 User Guide
Configuring the Switch
6. Select Next when you are done. A Modify Threshold window
appears, where you can change the % utilization, cumulative
minutes for the threshold to occur before notification, and the
time interval for measuring throughput and for alert notification.
7. Make appropriate changes, then continue through the Modify
Threshold windows, making changes as necessary, until the
summary screen appears displaying the alert configuration.
8. Perform either of the following steps:
• To change any parameters, select Previous/Next to display
the desired Modify Threshold window.
• Select Finish when you are done.
Activating or
Deactivating Alerts
Follow these steps to activate or deactivate existing threshold alerts.
In the active state, notifications are generated for the alert. In the
inactive state, notifications do not occur.
1. Click Configure on the Product Manager menu bar and select
Threshold Alerts on the drop-down menu.
This displays the Configure Threshold Alerts window
(Figure 5-20 on page 5-34). The port’s current state, deactive or
active, is listed under the State column.
2. To change the state, select the alert next to the alert information in
the table.
3. If the alert is active, select Deactivate. If the alert is inactive, select
Activate.
Deleting Alerts
Follow these steps to delete existing threshold alerts:
1. Click Configure on the Product Manager menu bar and select
Threshold Alerts on the drop-down menu.
This displays the Configure Threshold Alerts window
(Figure 5-20 on page 5-34).
2. Select the alert that you want to delete by selecting the alert
information in the table.
3. Select Delete.
4. A message displays asking you to confirm the deletion.
Select Yes.
To Next Page
Loading...