5
5-6
Connectrix DS-32M2 User Guide
Configuring the Switch
Configuring Operating Parameters
Use the procedures in this section to configure the following Fibre
Channel operating parameters. The operating parameters are stored
in NV-RAM on the switch.
Ordinarily, you do not need to change these values from their defaults. The
only exception is the Preferred Domain ID. Change this value if the switch
will participate in a multiswitch fabric.
To configure operating parameters for the switch, follow these steps:
1. Set the switch off line.
CAUTION
!
Setting the switch off line terminates all Fibre Channel
connections.
a. Click Maintenance on the Product Manager menu bar and
select Set Online State on the drop-down menu.
This displays the window shown in Figure 5-4.
Figure 5-4 Set Online State Window
b. Click Set Offline.
2. Click Configure on the Product Manager menu bar and select
Operating Parameters on the drop-down menu.
This displays the dialog box in Figure 5-5.
To Next Page
Loading...