5
Configuring Port Addresses
5-19
Configuring the Switch
All port addresses for the switch are listed across the top of the
matrix to the right of the first three columns. The addresses are
also listed down the left side of the dialog box. If a cell (square) in
the matrix contains a red circle-and-line symbol (shown in several
cells in Figure 5-9), connection is prohibited between the two
addresses whose row and column intersect at that cell.
In Figure 5-9, for example, port address 07 is prohibited from
communicating with port address 05. Also, Port OC is prohibited
from communicating with all other port addresses.
Moving the cursor over the cells in the array displays the corresponding
address.
2. Configure the parameters as described under Address Parameters
on page 5-20.
3. When everything is configured the way you want, click Save As
at the bottom of the Configure Addresses dialog box. This
displays the dialog box in Figure 5-10.
Figure 5-10 Save Address Configuration Dialog Box
4. Enter information as follows:
• Name — one to eight characters.
• Description, (optional) — Up to 24 alphanumeric characters.
Spaces, hyphens, and underscores are allowed.
Valid characters: A through Z (uppercase)
0 through 9
hyphen (-)
underscore (_)
Invalid names: CON
AUX
COM1, COM2, COM3, COM4
LPT1, LPT2, LPT3
NUL
PRN
To Next Page
Loading...