5
Configuring Management Server Control
5-27
Configuring the Switch
Configuring Management Server Control
This section describes the procedure to configure a management
server (assuming the Management Server feature is installed). The
procedures are different for Open Systems and S/390 operating
modes.
In the current Connectrix release, the Open Systems Management Server
feature is available only through RPQ.
Open Systems
Management
Server
Use these procedures to configure the open systems inband
management program to function with the switch.
The Open Systems Management Server feature must be installed in order to
perform this procedure.
To configure open systems management server, follow these steps:
1. Click Configure on the Product Manager menu bar and select
Management Server on the drop-down menu.
This displays the window in Figure 5-14.
Figure 5-14 Configure Open Systems Management Server Window
2. If the box next to Host Control Prohibited is checked, the host
management program cannot change configuration and
connectivity parameters on the switch. Clicking the checkbox
when it contains a checkmark removes the checkmark and allows
write authorization.
3. Click Activate to activate changes and close the dialog box.
4. If you are finished configuring the switch, you can back up the
configuration data. For more information, refer to Backing Up and
Restoring the Configuration on page 7-12.
To Next Page
Loading...