D
perfshow
D-57
Command Line Interface
show
The show branch of the CLI command tree contains commands that
display, but do not change, stored data values.The displayed output
that results from these commands might not be identical to the
output from the show commands that are within the other CLI
command tree branches; for example, config.port.show.
The commands in the show branch can by used by either the
Administrator or the Operator.
show.eventLog
Syntax eventLog
Purpose This command shows the contents of the event log as maintained in
NV-RAM on the switch.
Parameters This command has no parameters.
Command Example
Root> show eventLog
Output The event log data are displayed as a table that includes the following
properties.
◆ Date/Time — The date and time when the event occurred.
◆ Code — The event reason code.
◆ Severity — The severity of the event. The values are:
• Major —Unit operational (major failure).
• Minor —Unit operational (minor failure).
• Severe —Unit not operational.
• Info—Unit operational (information only).
◆ FRU — The FRU and FRU position, where applicable.
◆ Event Data — The 32-byte hexidecimal description of the event in
words.
To Next Page
Loading...