A
A-30 Connectrix DS-32M2 User Guide
Using SNMP to Manage the Switch
Threshold Alerts Group
Table A-17 Active Member Table
Variable Provides:
ef6000ZoneIndex The index of the zone this member belongs to.
ef6000MemberIndex Member index number. This number will range from 1 to the number of
members specified by the corresponding ZoneMemberCount.
ef6000MemberType Indicates the addressing method for this member (1=WWN, 2=Port Number).
ef6000MemberWWN The WWN name as an 8-character string. This value is only valid if the member
type is 1, otherwise it will default to 0.
ef6000MemberDomainID The domain ID. This value is only valid if the member type is 2, otherwise it will
default to 0.
ef6000MemberPortNumber The port number. This value is only valid if the member type is 2, otherwise it
will default to 0.
Table A-18 Threshold Alerts Table
Variable Provides:
ef6000TAIndex This object is used to identify which threshold has been triggered.
ef6000TAName The threshold alert name.
ef6000TAState The current state of the threshold (enabled=1, disabled=2).
ef6000TAType The type of the threshold. (throughput=1, counter=2)
ef6000TAPortType A threshold can be set on a list of physical port numbers or on all the ports of
the specified type (list=1, ePorts=2, fPorts=3, flPorts=4)
ef6000TAPortList A bitmap that identifies which ports this threshold alert applies to (only valid
when the threshold alert port type = list). The left-most bit represents port 0.
ef6000TAInterval The number of minutes in a threshold alert interval.
ef6000TATrggerValue If the alert type is a Throughput Thrreshold Alert, this is the percent of utilization
(1-100) required to trigger an alert. If the alert type is a Counter Threshold Alert,
this is the counger delta required to trigger an alert.
To Next Page
Loading...
Need help?
General
