EMC Connectrix DS-32M2 - Addresses and Storage

5
5-18
Connectrix DS-32M2 User Guide
Configuring the Switch
Configuring Port Addresses
This operation applies only if the switch’s operating mode is set to S/390.
(Refer to Configuring the Operating Mode on page 5-4.)
Use this procedure to create and activate port address configurations
for S/390 connections.
To configure, save, and activate port addresses, use the following
steps:
1. Click Configure on the Product Manager menu bar and select
Addresses on the drop-down menu; then click Active on the
pop-up submenu.
This displays the dialog box in Figure 5-9.
Figure 5-9 Configure Addresses - “Active” Dialog Box