D
D-70 Connectrix DS-32M2 User Guide
Command Line Interface
◆ Switch Priority — The switch priority as set in the
config.switch.priority command.
◆ Speed — The switch speed as set in the config.switch.speed
command.
◆ Rerouting Delay — The rerouting delay as set in the
config.switch.rerouteDelay command.
◆ Operating Mode — The operating mode (Open Systems or
S/390). This attribute cannot be configured through the
command line interface.
◆ Interop Mode — The interoperability mode as set in the
config.switch.interopMode command.
◆ Active Domain Id — The active domain ID of the switch. This ID
may or may not be the same as the preferred domain ID.
◆ World Wide Name — The World Wide Name for the switch.
Output Example The output from show.switch is similar to the following:
show.system
Syntax system
Purpose This command displays a set of system attributes.
Parameters This command has no parameters.
Command Example
Root> show system
Switch Information
State: Online
BB Credit: 2
R_A_TOV: 20
E_D_TOV: 4
Preferred Domain Id: 1
Switch Priority: Default
Speed: 2 Gb/sec
Rerouting Delay: Enabled
Operating Mode: Open Systems
Interop Mode: Open Fabric 1.0
Active Domain Id: 1
World Wide Name: 10:00:08:00:88:00:21:07
To Next Page
Loading...