g-4
Connectrix DS-32M2 User Guide
Glossary
• A switch with Operating Mode set to Open Systems and Interop
Mode set to McDATA 1.0 is added to the fabric. (Refer to
Configuring the Operating Mode on page 5-4.)
• An ISL is removed.
C
Call Home A product feature that allows the Connectrix service processor to
automatically dial out to a support center and report system
problems. The support center server accepts calls from the Connectrix
service processor, logs reported events, and can notify one or more
support center representatives. Telephone numbers and other
information are configured through the Windows NT dial-up
networking application. The Call Home function can be enabled and
disabled through the Product Manager.
Channel Point-to-point link that transports data from one point to the
other.
Class 2 Fibre Channel
Service
In Class 2 service, the fabric and destination N_Ports provide
connectionless service with notification of delivery or nondelivery
between the two N_Ports.
Class 3 Fibre Channel
Service
Class 3 service provides a connectionless service without notification
of delivery between N_Ports. (This is also known as datagram
service.) The transmission and routing of Class 3 frames is the same
as for Class 2 frames.
CLI Command line interface.
Command Line
Interface
A display line on the screen, onto which the user enters commands.
Community A relationship between an SNMP agent and a set of SNMP managers
that defines authentication, access control, and proxy characteristics.
Community Name A name that represents an SNMP community that the agent software
recognizes as a valid source for SNMP requests. An SNMP
management program that sends an SNMP request to an agent
program must identify the request with a community name that the
agent recognizes or the agent discards the message as an
authentication failure. The agent counts these failures and reports the
To Next Page
Loading...