Enterasys G3G170-24 - Chapter 4: Port Configuration; Port Configuration Summary; Port String Syntax Used in the CLI

Enterasys G-Series CLI Reference 4-1
4
Port Configuration
ThischapterdescribesthePortConfigurationsetofcommandsandhowtousethem.
Port Configuration Summary
Port String Syntax Used in the CLI
Commandsrequiringaport‐stringparameterusethefollowingsyntaxtodesignateporttype,slot
location,andportnumber:
porttype.slotnumber.portnumber
Whereporttypecanbe:
gefor1‐GbpsEthernet
tgfor10‐GbpsEthernet
hostforthehostport
vlanforvlaninterfaces
lagforIEEE802.3li nkaggregationports
Slot
number(alsoreferedtoas“unit”or“module”numberintheCLI)canbe:
1‐4
Portnumbercanbe:
1–24
For information about... Refer to page...
Port Configuration Summary 4-1
Reviewing Port Status 4-3
Disabling / Enabling and Naming Ports 4-7
Setting Speed and Duplex Mode 4-9
Enabling / Disabling Jumbo Frame Support 4-12
Setting Auto-Negotiation and Advertised Ability 4-14
Setting Flow Control 4-18
Setting Port Link Traps and Link Flap Detection 4-19
Configuring Broadcast Suppression 4-28
Port Mirroring 4-30
Link Aggregation Control Protocol (LACP) 4-33
Configuring Protected Ports 4-47