Enterasys G3G170-24 - Set Dhcp Exclude; Clear Dhcp Exclude

set dhcp exclude
13-6 DHCP Server Configuration
Examples
ThisexampledisablesDHCPconflictlogging.
G3(rw)->clear dhcp conflict logging
ThisexampleclearstheconflictinformationfortheIPaddress192.0.0.2.
G3(rw)->clear dhcp conflict 192.0.0.2
set dhcp exclude
Usethiscommand toconfiguretheIPaddressesthattheDHCPservershouldnotassign toDHCP
clients.Multipl eaddressrangescanbeconfiguredbuttherangescannotoverlap.Upto128non‐
overlappingaddressrangescanbeexcluded.
Syntax
set dhcp exclude low-ipaddr [high-ipaddr]
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Example
Thisexamplefirstconfigurestheaddresspoolnamed“auto1”with255addressesfortheClassC
network172,20.28.0,withthesetdhcppoolnetworkcommand.Then,theexamplelimitsthe
scopeoftheaddressesthatcanbeassignedbyaDHCPserverbyexcludingaddresses172.20.28.80
–100,withtheset
dhcpexcludecommand.
G3(rw)->set dhcp pool auto1 network 172.20.28.0 24
G3(rw)->set dhcp exclude 172.20.28.80 172.20.28.100
clear dhcp exclude
UsethiscommandtocleartheconfiguredIPaddressesthattheDHCPservershouldnotassignto
DHCPclients.
Syntax
clear dhcp exclude low-ipaddr [high-ipaddr]
Parameters
low‐ipaddr SpecifiesthefirstIPaddressintheaddressrangetobeexcludedfrom
assignment.
high‐ipaddr (Optional)SpecifiesthelastIPaddressintheaddressrangetobe
excluded.
low‐ipaddr SpecifiesthefirstIPaddressintheaddressrangetobecleared.