Enterasys G3G170-24 - Clear Multiauth Port

clear multiauth port
Enterasys G-Series CLI Reference 20-35
Defaults
None.
Mode
Switchcommand,read‐write.
Examples
Thisexampleshowshowtosettheportmultipleauthenticationmodetorequiredonge.3.14:
G3(rw)->set multiauth port mode auth-reqd ge.3.14
Thisexampleshowshowtosetthenumberofusersallowedtoauthenticateonportge.3.14to8:
G3(rw)->set multiauth port numusers 8 ge.3.14
clear multiauth port
Usethiscommandtoclearmultipleauthenticationpropertiesforoneormoreports.
Syntax
clear multiauth port {mode | numusers} port-string
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Examples
Thisexampleshowshowtocleartheportmultipleauthenticationmodeonportge.3.14:
G3(rw)->clear multiauth port mode ge.3.14
Thisexampleshowshowtoclearthenumberofusersonportge.3.14:
G3(rw)->clear multiauth port numusers ge.3.14
port‐string Specifiestheport(s)onwhichtosetmultipleauthenticationproperties.
mode Clears thespecifiedport’smultipleau thenticationmode.
numusers Clearsthevaluesetforthenumberofusersallowedauthenticationonthe
specifiedport.
port‐string Specifiestheportorportsonwhichtoclearmultipleauthentication
properties.