Enterasys G3G170-24 - Clear Snmp Notifyprofile; Creating a Basic SNMP Trap Configuration

clear snmp notifyprofile
5-36 SNMP Configuration
Mode
Switchcommand,read‐write.
Example
ThisexampleshowshowtocreateanSNMPnotifyprofilenamedarea51 and a ssociateatarget
parametersentry.
G3(su)->set snmp notifyprofile area51 targetparam v3ExampleParams
clear snmp notifyprofile
UsethiscommandtodeleteanSNMPnotifyprofileconfiguration.
Syntax
clear snmp notifyprofile profile targetparam targetparam
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Example
ThisexampleshowshowtodeleteSNMPnotifyprofile“area51”:
G3(su)->clear snmp notifyprofile area51 targetparam v3ExampleParams
Creating a Basic SNMP Trap Configuration
TrapsarenotificationmessagessentbyanSNMPv1orv2agenttoanetworkmanagementstation,
aconsole,oraterminaltoindicatetheoccurrenceofasignificantevent,suchaswhenaportor
devicegoesupordown,whenthereareauthenticationfailures,andwhenpowersupplyerrors
occur.
ThefollowingconfigurationexampleshowshowtouseCLIcommandstoassociateSNMP
notificationparameterswithsecurityandauthorizationcriteria(targetparameters),andmapthe
parameterstoamanagementtargetaddress.
profile SpecifiesanSNMPfilternotifynametodelete.
targetparam
targetparam
SpecifiesanassociatedentryinthesnmpTargetParamsTable.
Note: This example illustrates how to configure an SNMPv2 trap notification. Creating an
SNMPv1 or v3 Trap, or an SNMPv3 Inform notification would require using the same commands
with different parameters, where appropriate. Always ensure that v1/v2 communities or v3 users
used for generating traps or informs are pre-configured with enough privileges to access
corresponding MIBs.