Enterasys G3G170-24 - Set Webview; Show Ssl

set webview
2-54 Basic Configuration
Mode
Switchcommand,read‐only.
Example
ThisexampleshowshowtodisplayWebViewstatus:
G3(rw)->show webview
WebView is Enabled.
set webview
UsethiscommandtoenableordisableWebViewontheswitch.
Syntax
set webview {enable | disable}
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Usage
ItisgoodpracticeforsecurityreasonstodisableHTTPaccessontheswitchwhenfinished
configuringwithWebView,andthentoonlyenableWebViewontheswitchwhenchangesneed
tobemade.
Example
ThisexampleshowshowtodisableWebViewontheswitch:
G3(rw)->set webview disable
show ssl
UsethiscommandtodisplaySSLstatus.
Syntax
show ssl
Parameters
None.
Defaults
None.
enable|disable EnableordisableWebViewontheswitch.