Enterasys G3G170-24 - Set Multiauth Mode; Show Multiauth

show multiauth
Enterasys G-Series CLI Reference 20-31
show multiauth
Usethiscommandtodisplaymultipleauthenticationsystemconfiguration.
Syntax
show multiauth
Parameters
None.
Defaults
None.
Mode
Switchcommand,read‐only.
Example
Thisexampleshowshowtodisplaymultipleauthenticationsystemconfiguration:
G3(rw)->show multiauth
Multiple authentication system configuration
-------------------------------------------------
Supported types : dot1x, pwa, mac
Maximum number of users : 768
Current number of users : 2
System mode : multi
Default precedence : dot1x, pwa, mac
Admin precedence : dot1x, pwa, mac
Operational precedence : dot1x, pwa, mac
set multiauth mode
Usethiscommandtosetthesystemauthenticationmodetoallowmultipleauthenticators
simultaneously(802.1xPWA,andMACAuthentication)onasingleport,ortostrictlyadhereto
802.1xauthenticati on.
Syntax
set multiauth mode {multi | strict}
set multiauth idle-timeout 20-38
clear multiauth idle-timeout 20-38
show multiauth session-timeout 20-39
set multiauth session-timeout 20-40
clear multiauth session-timeout 20-40
For information about... Refer to page...