Enterasys G3G170-24 - Ip Irdp Broadcast

ip irdp broadcast
Enterasys G-Series CLI Reference 16-37
Syntax
ip irdp preference preference
no irdp preference
Parameters
Defaults
None.
Mode
Interfaceconfiguration:G3(su)‐>router(Config‐if(Vlan1))#
Example
ThisexampleshowshowtosetIRDPpreferenceontheVLAN1interfacesothattheinterface’s
addressmaystillbeadvertised,butcannotbeusedbyneighboringhostsasadefaultrouter
address:
G3(su)->router(Config)#interface vlan 1
G3(su)->router(Config-if(Vlan 1))#ip irdp preference -2147483648
ip irdp broadcast
UsethiscommandtoconfigureIRDPtousethelimitedbroadcastaddressof255.255.255.255. The
defaultismulticastwithaddress224.0.0.1.ThenoformofthiscommandresetsIRDPtouse
multicastonIPaddress224.0.0.1.
Syntax
ip irdp broadcast
no ip irdp broadcast
Parameters
None.
Defaults
None.
Mode
Interfaceconfiguration:G3(su)‐>router(Config‐if(Vlan1))#
Example
ThisexampleshowshowtoenablebroadcastforIRDPontheVLAN1interface:
G3(su)->router(Config)#interface vlan 1
G3(su)->router(Config-if(Vlan 1))#ip irdp broadcast
preference Specifiesthevaluetoindicatetheinterface’suseasadefaultrouter
address.Validvaluesare‐2147483648to2147483647.
Theminimumvalueindicatesthattheaddress,eventhoughitmaybe
advertised,isnottobeusedbyneighboringhostsasadefaultrouter
address.