Enterasys G3G170-24 - Ipv6 Route Distance

ipv6 route distance
Enterasys G-Series CLI Reference 18-5
Defaults
Defaultpreferenceoradministrativedistanceis1.
Mode
Routerglobalconfiguration:G3(su)‐>router(Config)#
Usage
Usethenoformofthiscommandtoremoveastaticroute.Ifyoudonotspecifyanexthopaddress
withthenoform,allstaticroutestothespecifieddestinationwillberemoved.
Example
ThiscommandcreatesastaticIPv6routetonetwork2001:0DB8:2222:4455::/64bywayofinterface
VLAN6andgivesitapreferenceof5.
G3(su)->router(Config)# ipv6 route 2001:0DB8:2222:4455::/64 interface vlan 6
fe80::1234:5678:2dd:1 5
ipv6 route distance
Thiscommandconfiguresthedefaultdistance,orpreference,forstaticIPv6routes.
Syntax
ipv6 route distance pref
no ipv6 route distance
Parameters
Defaults
Defaultpreferenceoradministrativedistanceis1.
Mode
Routerglobalconfiguration:G3(su)‐>router(Config)#
pref (Optional)Specifiesthepreferencevaluetherouterusestocompare
thisroutewithroutesfromotherroutesourcesthathavethesame
destination.
Thevalueofprefcanrangefrom1to255.Thedefaultvalueis1,which
givesstaticroutesprecedenceoveranyothertype
ofrouteexcept
connectedroutes.
Aroutewithapreferenceof255cannotbeusedtoforwardtraffic.
pref Adistancevalueusedwhennodistanceisspecifiedwhenastatic
routeisconfigured.
Thevaluecanrangefrom1to255.Lowerroutedistancevaluesare
preferredwhendeterminingthebestroute.