Enterasys G3G170-24 - Set Boot System

set boot system
2-38 Basic Configuration
Syntax
show boot system
Parameters
None.
Defaults
None.
Mode
Switchcommand,read‐only.
Example
Thisexampleshowshowtodisplaytheswitch’sbootfirmwareimage:
G3(su)->show boot system
Current system image to boot: bootfile
set boot system
Usethiscommandtosetthefirmwareimagetheswitchloadsatstartup.
Syntax
set boot system filename
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Example
Thisexampleshowshowtosetthebootfirmwareimagefileto“newimage”:
G3(su)->set boot system newimage
filename Specifiesthenameofthefirmwareimagefile.