Enterasys G3G170-24 - Show Console

show console
2-26 Basic Configuration
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Example
Thisexampleshowshowtosetthesystemtimeoutto10minutes:
G3(su)->set logout 10
show console
Usethiscommandtodisplayconsolesettings.
Syntax
show console [baud] [bits] [flowcontrol] [parity] [stopbits]
Parameters
Defaults
Ifnoparametersarespecified,allsettingswillbedisplayed.
Mode
Switchcommand,read‐only.
Example
Thisexampleshowshowtodisplayallconsolesettings:
G3(su)->show console
Baud Flow Bits StopBits Parity
------ ------- ---- ---------- ------
9600 Disable 8 1 none
timeout Setsthenumberofminutesthesystemwillremainidlebeforetimingout.
baud (Optional)Displaystheinput/outputbaudrate.
bits (Optional)Displaysthenumberofbitspercharacter.
flowcontrol (Optional)Displaysthetypeofflowcontrol.
parity (Optional)Displaysthetypeofparity.
stopbits (Optional)Displaysthenumberofstopbits.