Enterasys G3G170-24 - Clear Spantree Spanguard; Show Spantree Spanguardtimeout; Set Spantree Spanguardtimeout

clear spantree spanguard
6-26 Spanning Tree Configuration
clear spantree spanguard
UsethiscommandtoresetthestatusoftheSpanningTreeSpanGuardfunctiontodisabled.
Syntax
clear spantree spanguard
Parameters
None.
Defaults
None.
Mode
Switchcommand,read‐write.
Example
ThisexampleshowshowtoresetthestatusoftheSpanGuardfunctiontodisabled:
G3(rw)->clear spantree spanguard
show spantree spanguardtimeout
UsethiscommandtodisplaytheSpanningTreeSpanGuardtimeoutsetting.
Syntax
show spantree spanguardtimeout
Parameters
None.
Defaults
None.
Mode
Switchcommand,read‐only.
Example
ThisexampleshowshowtodisplaytheSpanGuardtimeoutsetting:
G3(su)->show spantree spanguardtimeout
Spanguard timeout: 300
set spantree spanguardtimeout
Usethiscommandtosettheamountoftime(inseconds)anedgeportwillremainlockedbythe
SpanGuardfunction.