Enterasys G3G170-24 - Set Spantree Protomigration; Show Spantree Spanguard

set spantree protomigration
6-24 Spanning Tree Configuration
Parameters
None.
Defaults
None.
Mode
Switchcommand,read‐write.
Example
Thisexampleshowshowtocleartopolo gychangetrapsuppressionsetting:
G3(rw)->clear spantree tctrapsuppress
set spantree protomigration
UsethiscommandtoresettheprotocolstatemigrationmachineforoneormoreSpanningTree
ports.WhenoperatinginRSTPmode,thisforcesaporttotransmitMSTPBPDUs.
Syntax
set spantree protomigration <port-string>
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Example
Thisexampleshowshowtoresettheprotocolstatemigrationmachineonport20:
G3(su)->set spantree protomigration ge.1.20
show spantree spanguard
UsethiscommandtodisplaythestatusoftheSpanningTreeSpanGuardfunction.
Syntax
show spantree spanguard
Parameters
None.
port‐string Resettheprotocolstatemigrationmachineforspecificport(s).Fora
detaileddescriptionofpossibleport‐stringvalues,referto“PortString
SyntaxUsedintheCLI”onpage 4‐1.