Enterasys G3G170-24 - Ip Pimsm Enable; Ip Pimsm Staticrp

ip pimsm staticrp
Enterasys G-Series CLI Reference 16-47
ip pimsm staticrp
ThiscommandisusedtocreateamanualRendezvousPointIPaddressforthePIM‐SMrouter.
ThenoformofthiscommandremovesapreviouslyconfiguredRP.
Syntax
ip pimsm staticrp ipaddress groupadress groupmask
no ip pimsm staticrp ipaddress groupadress groupmask
Parameters
Defaults
None.
Mode
GlobalRouterconfiguration:G3(su)‐>router(Config)#
Example
ThisexampleshowshowtosetanRPforaspecificmu lticastgroup.
G3(su)->router(Config)# ip pimsm staticrp 192.15.18.3 224.0.0.0 240.0.0.0
ip pimsm enable
ThiscommandsetstheadministrativemodeofPIM‐SMmulticastroutingonaroutinginterfaceto
enabled.Bydefault,PIMisdisabledonallIPinterfaces.Thenoformofthiscommanddisables
PIMonthespecificinterface.
Syntax
ip pimsm enable
no ip pimsm enable
Parameters
None.
Defaults
None.
Mode
Interfaceconfiguration:G3(su)‐>router(Config‐if(Vlan1))#
Example
ThisexampleshowshowtoenablePIMonIPinterfaceforVLAN1.
G3(su)->router(Config)#interface vlan 1
G3(su)->router(Config-if(Vlan 1))#ip pimsm enable
ipaddress TheIPaddressoftheRendezvousPoint
groupadress ThegroupaddresssupportedbytheRendezvousPoint
groupmask Thegroupmaskforthegroupaddress