Enterasys G3G170-24 - Area Nssa Translator-Stab-Intv; Area Range

area nssa translator-stab-intv
19-14 OSPFv3 Configuration
area nssa translator-stab-intv
ThiscommandconfiguresthetranslatorstabilityintervaloftheNSSA.
Syntax
area areaid translator-stab-intv interval
no area areaid translator-stab-intv
Parameters
Defaults
Thedefaultintervalis40seconds.
Mode
RouterOSPFv3configuration:G3(su)->router(Config-router)#
Usage
Thestabilityintervalistheperiodoftimethatanelectedtranslatorcontinuestoperformitsduties
afteritdeterminesthatitstranslatorstatushas beendeposedbyanotherrouter.
Example
Thisexamplesetsthetranslatorstabilityintervalto60secondsforNSSA20.
G3(su)->router(Config-router)# area 20 nssa translator-stab-intv 60
area range
Thiscommandcreatesanaddressrangeforthespeci fiedNSSA.
Syntax
area areaid range ipv6-prefix/prefix-length {summarylink | nssaexternallink}
[advertise | not-advertise]
no area areaid range ipv6-prefix/prefix-length
Parameters
areaid SpecifiestheareaIDinIPaddressformat(dotted‐quad)orasadecimal
value.
interval Specifiesthe stabilityintervalinseconds.Thevalueofintervalcanrange
from0to3600seconds.
areaid SpecifiestheareaIDinIPaddressformat(dotted‐quad)orasadecimal
value.
ipv6‐prefix/prefix‐length SpecifiesIPv6prefixandthelengthoftheIPv6prefixfortheaddress
range.Theprefixmustbespecifiedinhexadecimalusing16‐bitvalues
betweencolons.
Thevalueofprefix‐lengthisa
decimalnumberindicatingthenumberof
high‐ordercontiguousbitsthatcomprisetheprefix.
summarylink SpecifiesthatroutesummarizationshouldbebasedonsummaryLSAs.