Enterasys G3G170-24 - Set Summertime Recurring

set summertime recurring
2-18 Basic Configuration
Defaults
Ifanoffsetisnotspecified,nonewillbeapplied.
Mode
Switchcommand,read‐write.
Example
ThisexampleshowshowtosetadaylightsavingstimestartdateofApril4,2004at2a.m.andan
endingdateofOctober31,2004at2a.m.withanoffsettimeofonehour:
G3(su)->set summertime date April 4 2004 02:00 October 31 2004 02:00 60
set summertime recurring
Usethiscommandtoconfigurerecurringdaylightsavingstimesettings.Thesesettingswillstart
andstopdaylightsavingstimeatthespecifieddayofthemonthandhoureachyearandwillnot
havetoberesetannually.
Syntax
set summertime recurring start_week start_day start_month start_hr_min end_week
end_day end_month end_hr_min [offset_minutes]
Parameters
Defaults
Ifanoffsetisnotspecified,nonewillbeapplied.
end_date Specifiesthedayofthemonthtoenddaylightsavingstime.
end_year Specifiestheyeartoenddaylightsavingstime.
end_hr_min Specifiesthetimeofdaytoenddaylightsavingstime.Formatishh:mm.
offset_minutes (Optional)Specifiestheamountoftimeinminutes
tooffsetdaylight
savingstimefromthenon‐daylightsavingstimesystemsetting.Valid
valuesare1‐1440.
start_week Specifies theweekofthemonthtorestartdaylightsavingstime.Valid
valuesare:first,second,third,fourth,andlast.
start_day Specifiesthedayoftheweektorestartdaylightsavingstime.
start_hr_min Specifiesthetimeofdaytorestartdaylightsavingstime.Formatis
hh:mm.
end_week Specifiestheweekofthe
monthtoenddaylightsavingstime.
end_day Specifiesthedayoftheweektoenddaylightsavingstime.
end_hr_min Specifiesthetimeofdaytoenddaylightsavingstime.Formatishh:mm.
offset_minutes (Optional)Specifiestheamountoftimeinminutestooffsetdaylight
savingstimefromthenon‐daylightsavingstimesystem
setting.Valid
valuesare1‐1440.